Sandpaper removes material; it does not simply make wood cleaner. The grit you start with determines how quickly the shape changes and how much work is needed to remove the scratches left behind. For a small finishing job, begin by identifying the wood surface and the intended finish rather than buying the roughest sheet.

Choose a starting grit and a finishing sequence

This approach is for known, bare wood or a documented coating that is safe to prepare. Do not sand an old unidentified painted surface, treated material or suspect composite as an experiment. Lead and other hazardous materials require a different assessment and work plan. Thin veneer also deserves caution because there may be very little decorative wood to remove.

Inspect under angled light. A lightly raised fiber on otherwise smooth wood needs less removal than a rough saw mark. Starting too coarse can create scratches deeper than the original defect. Test an inconspicuous area or a matching offcut, using modest hand pressure, and stop as soon as the surface condition you are addressing has changed.

Within a grit system, lower numbers are coarser and higher numbers are finer. The finishing product may specify a final preparation grit; follow that guidance instead of polishing every project to the highest number available. A surface that is too highly burnished may not take a chosen stain in the way you expect.

Move through an appropriate sequence that removes the preceding scratches without unnecessary extra abrasion. Inspect between stages and clear dust using a method suitable for the wood and finish. Do not jump to a very fine sheet and press harder to erase coarse marks. Pressure is not a substitute for the correct abrasive step.

Choose a backing that preserves the shape

Wrap paper around a flat block when you need to keep a flat face flat. Flexible pads can follow curves, but fingertips pressing through loose paper may make hollows around a small defect. Fold or size the paper so you can control the contact area without catching neighboring edges. Replace clogged or worn abrasive rather than leaning on it harder.

Wear suitable eye and dust protection and control the dust at the work area. A small hand-sanding job can still produce fine particles. Keep food, textiles and household traffic away from the work, and do not blow dust through the room. The aim is an even surface prepared for a specific coating, not the removal of the largest possible amount of wood.